User guide

5 Amico Architectural

Anchor base of column to oor (hardware by others). Note that base does not have to be

removed to complete this step. See gure 1.

Structural bracket(s) and hardware to attach to Amico column are to be supplied and installed

by others (see gure 3). Amico provides 2 “c” channels attached to the column to mate with this

structural support (see gure 2).

All line voltage devices within the column are pre-wired to dedicated junction boxes, located as

per shop drawings (either inside the column, or located outside the column via conduit).

Connect normal and emergency power at these junction boxes.

Amico provides a low voltage termination box and conduits, located as per shop drawings, to

the low voltage devices within the column. Low voltage devices are supplied, installed, and

wired by others.

All medical gas and vacuum outlets within the column are manifolded to a single point

connection for each gas at the top of the column to facilitate installation. Appropriate

contractor to connect to hospital supply at this point, following applicable building code(s).

Insert laminate panels removed in step 1.