Manual

MOUNTING OF ACCESSORIES

Figure 5

4. Once the accessory is at the desired height, tighten all four set screws to the tightest possible position on the

adapter using 1/8" (0.3175 cm) hex key.

5. Re-install the mounting channel stoppers onto the mounting channel by attaching them to the two holes on the

bottom of the channel (Figure 5).

WARNING The channel stoppers will break if screw is over tightened.

6. Reinstall the mounting channel covers, trim o excess covers in order to t them into the channel (Figure 4).

Mounting

Channel

Mounting

Channel

Stopper