Owner's manual
www.amico.com 5
Features
Description of the Alarm
• Microprocessor based digital LCD and individual microprocessor on each sensor module
• Gas-specic sensors can be mounted locally or remotely, up to 100 feet [30.5 m], utilizing 22 gauge shielded
twisted pair (2 shielded wires)
• DISS gas-specic sensor housed in a tamper-proof enclosure. The Sensor Module is housed in an anodized
aluminum and nickel-plated brass enclosure to act as an interference barrier
• The Sensor Module is the smallest computer-calibrated temperature-compensated sensor in the industry
• PSI, kPa, inHg or BAR display (programmable)
• Self diagnostic circuitry with error display for problem identication
• Highly accurate Solid State Pressure piezo-resistive transducer
• Dry contacts for remote monitoring from LCD for a generic alarm condition
• Modules are factory mounted on a hinged frame assembly for ease of installation and maintenance
• Field programmable push buttons for adjustment of “HI” and “LOW” set-points on display module
• LCD Alarm available in 1 to 8 gases
SHIPMENT DETAILS
When you receive an Alert-3 LCD series alarm from Amico Corporation, the package will consist of three main sections:
the Alarm Back Box, Sensors and the Frame/Module Assembly.
THE ALARM BACK BOX
The Alarm Back Box contains the auto-switchable System Power Supply with an ON/OFF switch, a built-in fuse and
terminal blocks (115 to 220 VAC - 50 to 60 Hz). The back box also incorporates the pipe stubs for applications that require
locally (in box) mounted sensors.
THE FRAME/MODULE ASSEMBLY
The Frame/Module Assembly consists of the frame and the LCD module. The hinged frame is designed to swing down
from the back box to facilitate installation and servicing of the alarm. This design will reduce installation time and
eliminate the risk of improper installation since all the modules are connected and tested at the factory.