OPERATING AND MAINTENANCE MANUAL COOKER HOOD OSC 6468 W, OSC 5468 W OSC 6458 I, OSC 5458 I IO 00150/2
IO 00150/2
Dear customer, You are now a user of the newest generation of cooker hood, type "OSC 6468 W, OSC 5468 W, OSC 6458 I, OSC 5458 I". This hood has been specially designed with your expectations in mind, and will undoubtedly form part of a kitchen fitted in the most modern style. Its high functional and aesthetic standards are ensured by our modern manufacturing techniques and use of state-of-the-art technology.
Air outlet (ø mm) Output (m3/h) Power consumption (W) Noise level (dBA) Net weight (kg) 120 290 max. 115 max. 50 4 (50 cm); 4,9 (60 cm) III Fittings and Construction The kitchen hood consists of the following elements (fig.1): - the hood case A, equipped with a ventilator exhaust B (as an extractor) and F (as an absorber), - a set of switches D, - a flange C for connecting the off-take pipe, - a stopper covering the opening of outlet B (for use in the absorber version only). Fig.
8. Check that the voltage (230V ~50 Hz) stated on the rating plate is consistent with the parameters your house’s electricity supply, and that the supply is marked as ~ (AC). ATTENTION: before connecting the cooker hood to the power supply, always check that the power lead is correctly attached and has NOT been crushed by the hood during installation. 9. If the power lead is damaged, it should be replaced by a qualified electrician. 10.
2. Connecting to the mains electricity and checking the function. After connecting to the mains electricity supply, (in line with the instructions above) check that the motor and lighting of the hood are functioning correctly. 3. Setting the cooker hood’s operating mode 3.1 Setting the hood in extraction mode When the hood is operating in extraction mode, the air is removed outside using a special pipe. When on this setting, any carbon filters should be removed.
- switch „O” controls the lighting. Sliding it to the left switches the lighting on, while sliding it to the right switches it off. - switch „W” activates the hood’s motor. Sliding it to the left activates the motor’s series of three operating settings. By adjusting this, the optimum rotation speed can be chosen for the ventilator according to the user’s requirements and for the minimum noise level. 3. Maintenance.
c) Replace mesh „A”. 3.4 Cleaning When cleaning the cooker hood, do not use: - solvents or alcohol, as they may tarnish lacquered surfaces - corrosive or abrasive substances, particularly when cleaning stainless steel surfaces It is best to use a damp cloth or neutral liquid cleaning agents.
Disposing of the device When disposing of the device, do not bring it to regular municipal waste containers. Instead, bring it to electrical and electronic waste recycling and reuse center. A relevant label has been put on the device, its instructions manual, or on the package. The device has been manufactured of recyclable materials. By bringing old device to recycling collection center, you show that you care about nature.
