Operation Manual
17
OPERATION
Control Panel
● Immediately after the appliance is connected to electrical mains, all displays will light up
briey. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensor elds, which are
operated by touching with a nger for at least 1 second.
● Touching of a sensor eld is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor elds (this could cause an error).
Touch sensor elds should be always kept clean.
Selecting the cooking zone heat setting
When the cooking zone display (3) shows bright “0”, start setting the desired heat setting
using the „+” (2) or „-” (4) sensor eld.
Switching on the cooking zones
Once the appliance is switched on using the on/off sensor eld (1), select a cooking zone (5)
within the next 20 seconds.
1. When a cooking zone selection sensor eld (5) is touched, „0” on the corresponding heat
setting indicator display will become bright.
2. Set the desired heat setting using the „+” (2) or „-” (4) sensor elds.
Switching on the appliance
To switch on the appliance touch and hold the on/off sensor eld (1) for at least 1 second. All
displays (3) will show the number „0”.
If none of the sensor elds is touched within 20 seconds, the appliance switches
itself off.
If none of the sensor elds is touched within 20 seconds of switching on the
appliance, the cooking zone switches off.
A cooking zone is active when its display shows a digit or a letter. This indicates the
cooking zone is ready for the heat setting to be set or changed.