Operation Manual

OPERATION

Booster function „P”

The Booster Function increases the nominal

power of the 210 mm cooking zone from 2100 W

to 3700 W.

When a cooking zone is active (3), activate

the booster function by touching the „P” sen-

soreld(6). Activation of the booster function

will be indicated by the letter „P” shown on the

relevant cooking zone display (3).

To switch off the Booster function, touch the

heat setting selection sensor eld(2) and

reduce the heat setting, or lift the pot from

the cooking zone.

Operation of the Booster function is

limited to 10 minutes. Once the Bo-

oster function is automatically deac-

tivated, the cooking zone continues

to operate at its nominal power. The

Booster function can be reactivated,

provided the appliance electronic

circuits and induction coils are not

overheated.

When the pot is lifted from the co-

oking zone when the Booster func-

tion is in operation, it remains active

and the countdown continues.

Selecting the cooking zone heat setting

When the cooking zone display (3) shows „0” and a decimal point, start setting the desired

heatsettingbyslidingyourngeracrosstheheatselectionsensoreld(2).

If none of the sensor elds is touched within 20 seconds then the cooking zone

switches off.

When the appliance electronic circuits or

induction coils overheat when the Booster

function is in operation, it is automatically

deactivated. The cooking zone continues

to operate at its nominal power.

A cooking zone is active when its display shows a digit or a letter and a decimal point.

This indicates the cooking zone is ready for the heat setting to be set or changed.