Operation Manual
14
OPERATION
Switching on the appliance.
JWhen the appliance is switched off then all
the cooking zones are disconnected and the
indicators are off.
Touch the on/off sensor eld (1) to switch on
the appliance. „0” will appear on all cooking
zone displays (3) for 10 seconds. Select co-
oking zone by touching cooking zone selector
sensor eld (2) and then slide your nger
across the setting setting selection sensor
eld (4) to set the desired heat setting (see
Selecting the cooking zone heat setting).
If none of the sensor elds is touched within 10 seconds, the appliance swit-
ches itself off. If child lock function is activated, the appliance cannot be swit-
ched on (see „Releasing the child lock”).
Switching on the cooking zones
Control Panel
When the cooking surface is connected to
the electricity mains, the pilot light should
light up briey above the child lock sensor
eld (7), after which the appliance can be
switched on.
No objects should be placed on the sensor elds (this could cause an error).
Touch sensor elds should be always kept clean.
After switching on the appliance using the on/off
sensor eld (1) cooking zones can be operated
as follows:
1. Select the desired cooking zone using the
cooking zone selector sensor eld (2). (Sensor
eld layout reects the layout of individual co-
oking zones),
2. To select the desired heat setting, slide your
nger across the setting selection sensor eld
(4).
3. To change the heat setting again as described
in point 1, select the desired cooking zone
using the cooking zone selector sensor eld
(2), and then slide your nger across the heat
setting sensor eld (4).
7
2
1
4
2
2
3
3
3
3
2
4
2
2