Operation Manual

18
OPERATION
The electronic prgrammer Ts is equipped
with electronic sensors which are
switched on by touching or pressing
the sensor surface for at least one
second.
Eachsensorreactionisconrmedby
the beep.Keep the sensor surface clean
at all times.
Important!
In ovens equipped with the electronic
programmer Ts, the time “0.00” will
startashinginthedisplayeldupon
connection to the power supply.
The programmer should be set with
the current time. (See Electronic
programmer ). If the current time
is not set operation of the oven is
impossible.
Before using the oven for the rst time
 Remove packaging, clean the interior of
the oven and the hob.
 Takeoutandwashtheoventtingswith
warm water and a little washing–up liq-
uid.
 Switch on the ventillation in the room or
open a window.
 Heat the oven (to a temperature of 250°C,
forapprox.30min.),removeanystains
and wash carefully; the heating zones
of the hob should be heated for around
4 min. without a pan.
Important!
To clean the oven, only use a cloth
well rang out with warm water to
which a little washing-up liquid has
been added.