Operation Manual

OPERATION
Menu / user programs
Select user programmes menu and touch
. 10 fully customisable user programmes
are available.
Operating user programmes
Using navigationsensorelds,select
a user program such as P0 and touch , to
conrmyourselection.Theappliancedisplay
will show the default settings for all P0-P10
user programmes, which are the same as
those shown below: conventional cooking,
temperature 180°C and cook time 00:30.
If no changes are made within 3 minutes, the
appliance switches to standby mode.
Place food in the open, close the door and
touch .sensoreldtostarttheprogramme.
Theprogrammeisstarted.Inbox2ofthepre-
set programme COOK TIME changes to END
TIME and consequently cook time of 0:30 is
replaced with end time and the remaining time
is shown on the progress bar.
Once the programmed cook time has
elapsed,allfunctionsexceptcoolingfanare
turned off (see: Cooling fan operation) and an
acoustic signal is sounded (4 beeps / pause
/ 4 beeps).
The sequence is repeated every 3 seconds
for about 5 minutes. The display shows the
temperature set for the oven chamber and
END TIME and symbolisashing.
12
3
Touch ,to acknowledge and mute the
acoustic signal. After this, the appliance
switches to standby mode.
Editing user programme settings
To modify the heating function and COOK
TIME, touch and hold sensoreldandthen
touch . sensoreld. Functionname and
symbolstartashinginbox3.Ifnochanges
are made within 3 minutes, the appliance
exitstouppermenu(UserProgrammes)and
stores settings last shown on the display.
Onlychangesconrmedbytouching are
updated.
Touch . navigation sensor fields to
change the heating function. Available heat-
ing functions are described in section Menu
\ Heating functions.
Select the desired function and touch .
sensoreldtoconrm.Aftertouchingthe
sensoreld,heating function symbol and
namestopashinginbox3.Atthesametime
symbolstartashinganditispossibleto
modify the temperature. If no changes are
madewithin3minutes,theapplianceexits
to upper menu (User Programmes) and
stores settings last shown on the display.
Onlychangesconrmedbytouching are
updated.
27