Operation Manual

11
OPERATION
TheelectronicprgrammerTsisequipped
with electronic sensors which are
switched on by touchingorpressing
the sensor surface for at least one
second.
Eachsensorreactionisconrmedby
thebeep.Keepthesensorsurfaceclean
atalltimes.
Important!
Inovensequippedwiththeelectronic
programmerTs,thetime“0.00” will
startashinginthedisplayeldupon
connectiontothepowersupply.
The programmer should be set with
the current time. (See Electronic
programmer ). If the current time
is not set operation of the oven is
impossible.
Before using the oven for the rst time
The oven is equipped with a retractable
knobs. In order to select a function do the
following:
1. Gently press and release a knob which
willpopout,
2.Turntheovenfunctionsselectionknobto
thedesiredfunction.
Symbols printed around the knob indicate
availableovenfunctions.
1
2
 Removepackaging,cleantheinteriorof
theovenandthehob.
 Takeoutandwashtheoventtingswith
warmwaterandalittlewashing–upliq-
uid.
 Switchontheventillationintheroomor
openawindow.
 Heattheoven(toatemperatureof250°C,
forapprox.30min.),removeany stains
and wash carefully; the heating zones
ofthehobshouldbeheatedforaround
4min.withoutapan.