Operation Manual

26
OPERATION
Cleaning programme.
Cleaning programme can be found in the
"Heating functions", but it operates much
like pre-set programmes. You can select the
following heating programme:
- Pyrolytic cleaning (depending on the mod-
el)
- Cleaning
Cleaning.
Pre-set cleaning programme: temperature
90°C, top heater + bottom heater, duration =
30 minutes with no fast heat-up. The clean-
ing symbol is shown.
The message "Add 50cl water and touch OK
to start" is displayed.
Aqualyticenamel oven(marked bythe let-
ters Qa).
Pour 50 cl (two glasses) of water on the bot-
tom of the oven chamber.
Standard enamel oven (marked by the let-
ter Q).
Insert the bread baking tray on the lowest lev-
el and pour 25 cl (one glass) of water into it.
"Cleaning" is shown on the display.
You can modify the pre-set cleaning pro-
gramme settings.
Pyrolytic cleaning*
The Pyrolytic cleaning programme comes
with special requirements. The message
"Remove all items from the oven and touch
OK”.
You need to conrm the setting within 10
minutes.
When you conrm the message is dis-
played: "Select pyrolytic cleaning duration"
and the choices are: 90 minutes, 120 min-
utes and 150 minutes Use controls to make
your choice.
Whenyouconrmdoorstatusischecked.If
the door is open the message "Close oven
door and touch OK to start" is displayed. If
the door is closed the message is displayed:
"Touch OK to start pyrolytic cleaning" You
have 10 minutes to close the door and touch
OKtoconrm.
Pyrolytic cleaning starts. The door is locked.
The symbols and are shown. Top grill
heater and bottom heater operate with tem-
perature setting of 480°C and cooling fan
operates at speed 2. The temperature is set
to 465°C and bottom heater operate inter-
mittently. The message "Caution! Pyrolytic
cleaning!"
30 minutes ahead of End Time all heaters
are turned off, temperature changes to "---
°C" and the message changes to "Cooling
down."
Based on the cooling rate the appliance cal-
culates and displays the time remaining until
the end of the pyrolytic cleaning.
The door is unlocked when temperature is
less than 150°C.
The cooling fan slows down to speed 1.
No settings can be changed during the py-
rolytic cleaning and you cannot continue
cooking with these settings. When you si-
lence the alarm, the appliance always en-
ters operating mode. Touch to terminate
the pyrolytic cleaning.
If there is a short power outage during py-
rolytic cleaning the appliance starts cooling
down and eventually unlocks the door.
When you touch to abort pyrolytic clean-
ing the appliance starts cooling down and
eventually unlocks the door. When the door
is unlocked the appliance switches to stand-
by.
When you touch OK to start pyrolytic clean-
ing and open the door before it is locked
therewillbean[opendoor]beepandpyro-
lytic cleaning is aborted.
*optional