Operation Manual

12
OPERATION
Before using the appliance for
the rst time
Important!
To clean the oven chamber use only
warm water and a small amount of
washing-upliquid.
 Remove packaging, clean the interior of
the oven,
 Take out and wash the oven accessories
with warm water and a little washing-up
liquid,
 Turn on the ventilation in the room or
open a window,
 Heat up the oven (to a temperature of
250°C for approximately 30 minutes),
remove any stains and wipe the interior
carefully. (See section: Using the control
panel),
Important!
The oven features touch control panel
and display. To activate each touch
sensor, touch the glass above the
sensor (indicated by a pictogram). An
acoustic signal will be heard.
On/off switch is on the right side
of the display. To activate each touch
sensor, touch the glass above the
sensor (indicated by a pictogram). An
acoustic signal will be heard, which
was selected in the menu. (See sec-
tion: Using the control panel),
Touch sensor surfaces must be
kept clean.
Some models are equipped with
a backlit oven door handle. For
additional information on oven ac-
cessories depending on the model,
please see section Features and
components.
Oven handle backlight is turned on
during operation and acts as oven
cavity residual heat indicator, i.e. it
turns off when the temperature inside
the oven cavity drops below 50°C.
The backlight is on above 50°C and
lightintensityreectsthetemperature,
i.e. the higher the temperature inside
the oven cavity the higher the back-
light intensity.