User's Manual

A9245-E-001 User Guide

Installation with FCC Approval

(1) This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

(2) Electrical connection, commissioning, measurement, maintenance, and

calibration work on the unit is to be performed only by electrical specialists or

persons with equivalent training.

(3) In countries or geographical regions where FCC approval is required, AMIC A9245-E

RFID reader may only be operated using the built-in antenna supplied

(4) Changes or modifications not expressly authorized by the relevant approval body

may result in revocation of the user’s operating permission.

(5) To comply with the FCC RF exposure compliance requirements, this device and its 

antenna must not be co-located or operating to conjunction with any other antenna or 

transmitter.



Note: This equipment has been tested and found to comply with the limits for a Class B 

Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instruction, may cause harmful interference to radio 

communication. However, there is no grantee that interference will not occur in a particular 

installation. If this equipment dose cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on , the user is 

encouraged to try to correct the interference by one or more of the following measures:



--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.