User's Manual

Table Of Contents

A9240-A-001-485 User Manual

NOTE: The changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

CC INFORMATION

he Federal Communication Commission Radio Frequency Interference Statement includes the following

aragraph:

he equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to

art 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

terference in a residential installation. This equipment generates, uses and can radiate radio frequency

nergy and, if not installed and used in accordance with the instruction, may cause harmful interference to

dio communication. However, there is no grantee that interference will not occur in a particular installation. If

is equipment dose cause harmful interference to radio or television reception, which can be determined by

rning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

e following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

he user should not modify or change this equipment without written approval

orm AMIC Communication Co. Modification could void authority to use this equipment.

To comply with the FCC RF exposure compliance requirements, this device and its antenna must

not be co-located or operating to conjunction with any other antenna or transmitter.