System information

Section 3 – Operator Screens
74 21822706
8.7 Input/Output Tests
The Input/Output Tests screen will allow testing
of various input and output circuits in the jukebox.
Rowe Controller: Press the buttons on the Rowelink Controller inside the jukebox to test the functionality of each button.
As the button is pressed, the box next to that button will turn orange.
Output Tests: The Money Meter and Reset Router outputs may be tested from this page. Touch the button next to Tick
Money Meter to pulse the meter. Touch the button next to Reset Router to cause the router’s power reset relay to pulse.
VCU: To test the functionality of a wired remote control and its receiver, push the button on the remote control. Once
pushed, the box next to the button will turn orange. If a button is pushed and nothing changes on this screen, verify that the
red LED on the receiver is blinking. This indicates the receiver is receiving a valid signal from the transmitter.
IR Remote: The IR Remote transmitter and receiver may be tested from this page. Simply push a button on the IR remote
control and the box next to the button will turn orange. If a button on the transmitter is pushed without any changes, verify
that the red LED on the IR receiver is blinking. This indicates that the receiver is receiving a valid IR signal from the
transmitter.
To return to the Service Mode – Main Menu, touch the Back button.