System information

Section 3 – Operator Screens
21822706 59
6.7 Paging Microphone Setup
The Paging Mic Setup screen allows you to set up
paging microphone options. The Rowe Studio
Sound AV Controller has three microphone inputs,
the Rowe 4-channel Preamplifier has two
microphone inputs, and the Rock-Ola preamplifier
has one microphone input. If none of these
preamplifiers are used, this screen will not be
available.
Each of the three microphones in the Rowe Studio Sound AV Controller and the two microphones in the Rowe 4-Channel
Preamplifier can be one of two types– Karaoke or Paging. Touch the button to select the Type
for each microphone.
There is only one microphone input on the Rock-Ola Digital
Sybersonic preamplifier and this microphone is for paging only.
When the Rock-Ola preamplifier is installed, the screen will display
only limited options (see the image to the right).
The microphone(s) can also be routed to specific audio channels. A check in any of the boxes in the Routing matrix enables
the selected microphone for that channel. The Rock-Ola preamplifier does not support AuxR or AuxL channels.
The Microphone Volume During Paging setting is used to set the microphone volume when the selected microphone is
active. This option is not available with the Rock-Ola preamplifier.
The Audio Volume During Paging setting is used to reduce the audio volume for any song that may be playing when the
selected microphone is active. If the audio volume is at or below this setting, operating the paging microphone will not
change the audio level.
To save your changes and return to the Service Mode – Main Menu, touch the Save button.
Touch the Cancel button to undo your changes and exit the screen.