System information

Section 1 – Network
4 21822706
Programming the Wireless Router
Introduction
The broadband installer should have left a document describing specific information required to connect to the
Internet Service Provider (ISP). This document may have included a User Name and Password and/or several IP
addresses. An IP address is a number used to identify an address on the Internet. This information will be used
to program the router.
The software in the jukebox provides access to the router setup screens so a laptop or other computer is not
required for setting up the router.
Router Setup Screen
Description
Be sure the broadband equipment and the router are powered up and the proper status LEDs on all equipment
are lit. Power up the jukebox and wait for the User Interface to appear. Open the jukebox and press the
SERVICE button on the Rowelink Controller to enter the Service Mode. Touch the Hardware Setup button and
then touch Router Setup. The screen should look like the figure above. If you get a LOGIN screen, touch the
text box next to User Name, type in “admin” and then touch the Log In button (leave the Password field blank).
If you get a “Page Not Found” error screen, see section 5 of your service manual for troubleshooting suggestions.
To change a value in the router, first touch the text box on the router setup view that is to be changed. This sets
the focus to that text box. Touch keys on the keyboard displayed at the bottom of the screen to enter new data.
Note
For security purposes, several of the router configuration pages have been disabled including the Setup Wizard
and the HELP page. Full access to all router configuration pages is still available by using a laptop computer or
other computer device. If the router is configured using a different computer and the Administrator password or
the default IP address of the router is changed, you will no longer be able to use the jukebox software to access
and program the router.