Owner`s manual

COPYRIGHT © 2010 AMI ENTERTAINMENT NETWORK, INC.
PM0636-14 MEGATOUCH ION AURORA OWNER’S MANUAL
battery on the motherboard is incorrectly
replaced. Only replace the battery with the
same type recommended by the manufac-
turer. Dispose of used batteries according
to the manufacturer’s instructions.
Cleaning the Cabinet
• The cabinet should be cleaned with a
damp cloth and mild detergent. Always
apply the cleaner to the cloth and not
directly on the game. Liquids could
enter the cabinet and damage electron-
ics inside.
Cleaning the Joystick
• The joystick should be cleaned with a
damp cloth and mild detergent. Always
apply the cleaner to the cloth and not
directly on the game. Liquids could
enter the housing and damage elec-
tronics inside.
Cleaning the Touchscreen Monitor
• The touchscreen glass should be
cleaned with a damp cloth and isopro-
pyl alcohol or a non-ammonia cleanser.
Do not use any abrasive or vinegar-
based cleansers, as they will damage
the touchscreen glass.
NOTE: DO NOT USE ANY ABRASIVE
SOLVENTS, ACID OR VINEGAR-BASED
CLEANSERS ON THE MONITOR OR
SIDE DECALS. OVER TIME, SUCH
CLEANSERS COULD HARM THE
TOUCHSCREEN AND ERASE THE DE-
CALS. BE CAREFUL NOT TO USE COM-
MERCIAL CLEANERS CONTAINING
ANY OF THESE SUBSTANCES.
Cleaning the Fans and Vents
• The fans and vents should be cleaned
of any dust and grime on a regular
basis to ensure proper ventilation of
the game.
• To ensure proper operation of the
game, it is important that all fans are
operating correctly and that the airflow
is unobstructed. Make sure nothing is
placed inside the cabinet or next to the
fan vents that would inhibit the flow of
air. Also, if any fans are not operating,
it is important that they be replaced.
Watchdog Timer
This game has been equipped with a fea-
ture that allows it to automatically reboot if it
encounters a problem. When the watchdog
timer is enabled, it will reboot the machine
within 5 minutes after a failure, allowing the
game to automatically reset itself if a prob-
lem arises without needing a technician
present.
If you want to disable the watchdog timer,
set DIP switch 3 on the I/O board to the open
position and reboot the game.
Connecting a Printer
(German Games Only)
To connect a printer to the game as needed:
Locate the printer port in the back of the
game (see Figure 30). When the game en-
ters idle mode, connect the printer to the
printer port on the game.
NOTE: Some printers may cause the
game to reboot. Once the game has
rebooted and entered idle mode, the
printer will begin printing. Do not dis-
connect the printer until it is finished
printing.
Um einen Drucker an eine Maschine
anzuschliessen:
1. Den Druckeranschluss hinten am Gerät
feststellen (Siehe Fig. 34). Wenn das Gerät
in den Leerlauf übergeht, den Drucker am
Druckeranschluss des Geräts
anschliessen.
BEMERKUNG: Bei bestimmten
Druckern rebootet das Gerät. Nachdem
das Gerät dann in den Leerlauf
übergeht, beginnt der Druckvorgang.
Den Drucker bitte nicht abschalten
bevor der Druckvorgang beendet ist.
4
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | [phone] | +1.561.391.7200