Service manual

S-4000 ISBH+I Omron
Revised 11/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
1-48
F - SLEEVE INDEXER
1. INTRODUCTION
The indexer is used to clamp and feed sleeve
wiggans while sewing Imitation Buttonholes. It
can be preset to provide a line of buttonholes
straight or at an angle with the Wiggan edges.
Programs can be set for any number of
buttonholes up to 16 within a 63 maximum
travel and the space between each is also
adjustable. The outside indexer parts are the
following mechanismes: Bar movement ➊,
Clamping ➋ and Thread puller ➌.
1. Indexer is fi
xed by the wood screws to
the table 24.0107.1.000. The distance
between the machine base and the
indexer cover is 1mm. The indexer front
cover is aligned with the machine base.
2. The indexer clamp feet are installed on
the holder ➎ and are 22.3036.0.000
locked by the bracket ➍ 24.4018.0.000
3. Indexer is connected with the sewing
cam mechanism by the pin ➏.
To ensure correct return of the sewing
head to the working position, keep
clearance 8 ± 1 mm as shown on the
picture.
2. SEWING HEAD AND INDEXER CONNECTION