Service manual

S-4000 ISBH+I Omron
Revised 03/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
1-42
2. The correct position of the tension mechanism
a) remove the tension assembly ➌ from the shaft ➍
b) check if the distance between the stud slot edge and the pin ➎ is 3.5 mm If incorrect, it is
necessary to adjust the
position on the pin.
c) remove the pulley cover
and the head cover to obtain
a good access for this
adjustment. Switch off the
air supply.
d) disconnect the air tube ➏
from the cylinder.
e) loosen the nut ➐ and turn
thecylinder ➑ as necessary.
Turning clockwise the pin is
extended. Tighten the nut ➐
whenthe correct
measurement is obtained.
f) connect the air tube ➏ to the cylinder, open the air supply and install the covers.
3. Regulation of the tension discs opening
If the last stitch is not tightened, follow the below mentioned steps:
a) loosen the locking nut ➒ on the speed controller ➓
b) To obtain better tightening of the last stitch, tighten screw and lock the nut ➒ securely.
E - MACHINE ADJUSTMENTS