Service manual

S-4000 ISBH+I Omron
Revised 12/2008
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
1-33
E - MACHINE ADJUSTMENTS
9. ADJUSTMENT OF BARRING STITCHES
To properly set the first bar ➊, the second bar ➋ must be
properly adjusted.
1. Second bar adjustment
Insert a piece of paper under the clamp feet. Turn the
handwheel through the sewing cycle until the control
spring ➎ release the left shifter arm pocket ➏. Check
to see that the clamp plate starts to move to the left just
as the needle point rises from the work piece
approximately 1 mm.
If the adjustment is incorrect:
a) If the clamp plate moves when the needle
is in the work
a1) loosen the screws ➌ in the worm gear
a2) hold the worm gear ➍ by hand and turn the
handwheel counter clockwise slightly
a3) tighten the screws ➌ and recheck the
adjustment. Repeat as needed.
b) The clamp plate moves when the needle
tip is higher than 1 mm above the work
surface
b1) loosen the screws ➌ of the worm gear
b2) hold the worm gear ➍ by hand and turn the
handwheel clockwise
b3) tighten the screws ➌ and recheck the
adjustment. Repeat as needed.