Service manual

S-4000 ISBH+I Omron
Revised 12/2008
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
1-18
b) sewing with indexer
If it is necessary to interrupt the cycle during the sewing with indexer (example: needle
breakage, thread breakage ):
b1) press the Cycle Interruption button Î on the indexer. The machine stops in the home
position after buttonhole is finished.
b2) Indexer clamp feet stay down. By the and buttons you can shift indexer clamp feet
to the desired position and finish sewing by pressing the foot pedal ➌ with simultaneous
holding the button Î.
b3) If you need to take out the fabric, you can do it by pressing the foot pedal ➌ to the first position
and rejecting then. You can hold the fabric by pressing the foot pedal ➌ again and next
sequence is the same as in point b2.
- if it is necessary to interrupt the cycle because of the operator safety:
b4) press Emergency Stop Button ➍
b5) the machine stops immediately, the indexer clamp feet raise up and move to the home
position - see b2.
b8) release the button , press button and sew one dummy buttonhole,
to bring the needle bar to the home position.
D - MACHINE CONTROLS
1.7. When the work is done, switch the
machine off by the main switch ➐
by turning center clockwise to the O position,
then stop the air supply by closing valve
which is behind the regulator.