Service manual

S-4000 ISBH+I Omron
Revised 12/2008
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
1-16
D - MACHINE CONTROLS
1. PROGRESS FOR SEWING A BUTTONHOLE
1.1. Bring the machine to the home position according to the section C1.
After this setting, the machine will sew with
the indexer according to the parameters set
in the program.
1.2. Be certain that the machine is threaded correctly
according to the section C3 and insert the sewn
work under the clamp feet. To place a buttonhole,
use the adjustable front stop ➊ and side gages ➋.
Note: There are no side stoppers ➋ on machines
with positioning laser lights (see 3-70).
1.3. When the foot pedal ➌ is pressed to the first
position, the sewn work is clamped by the head
clamp feet. (Releasing the foot treadle will raise
the clamp feet).
Note: It is possible to set the control so that both
the clamping and the sew start are simultaneous,
consult the programming section for this
information.
a) sewing without indexer
check, if the message appears on the display. If not, follow steps
below:
The machine sews only 1 buttonhole.
b) sewing with indexer
check, if the message appears on the display. If not, follow steps
below:
press
press