Service manual

Table Of Contents

S-4000 CAED Omron

1-34

Revised 10/2009

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

E - MACHINE ADJUSTMENTS

11. CLAMP PLATE ADJUSTMENT

1. If the distance between the clamp plate cover ➊ and the throatplate edge ➋ is too large, proceed as

instructed in items 2 and 3. Recommended distance – 0,2 mm.

2. Loosen the nut ➌ in the lever groove ➍.

3. Insert the gap gauge 0,2mm into the gap between the clamp plate cover ➊ and the throatplate edge ➋.

Move the clamp plate ➎ onto the gauge and secure the position by tightening the nut ➌.

➊

➋

12. TRIMMING MECHANISM ADJUSTMENT

If the mechanism does not trim properly, do the following:

* Disconnect the air supply, close the clamp feet and move the clamp plate to the left from the shear edge.

1. Check the shear knife ➊ and throatplate

edges ➋. If they are damaged, they can be

sharpened or replaced with new parts.

2. Puss the trimming mechanism from the top

by your hand ➌ and check whether the

shears slightly overlap along the shear

edge. If they do not overlap, loosen the

screw ➍ M4 and turn the studs ➎. Secure

the position by tightening the screws M4.

0,2 mm

➑

➏ ➐

➊

➋