Service manual

Table Of Contents

S-4000 CAED Omron

1-30

Revised 10/2009

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

E - MACHINE ADJUSTMENTS

9. LOOPERS ADJUSTMENT

Before the adjustment, follow the instructions below:

· Turn the hand wheel and see carefully the position of the connecting rod ➊ on both extreme

positions of the looper movable arm ➋. Angle A ➌ and angle B ➍ should be even.

· If the angles are not even – loosen the hexagonal erection bolt ➎ and turn the eccentric

adjusting bolt nut ➏ as necessary. T

ighten the hexagonal erection bolt ➎.

· Turn the hand wheel to set the needle bar to the upper dead centre.

· Check that the needle is straight.

· Tilt the head onto the support pin and check that the mark ➐ on the looper cam ➑ is on the left

side. If it is on the right side, take the cam out and turn. Place the machine head back to the

operation position.

· Remove the cover ➒, disconnect pneumatic pipes from the clamping cylinder and take the

clamping assembly ➓ out. Remove the throatplate

, trimming hook cover and trimming

hook. Dismantle the holders with loopers.

ÊÊ

ËË

ÍÍ

ÌÌ

ÊÊ

ÏÏ

ÎÎ

➓

➒