Service manual

S-4000 CAED Omron
1-29
Revised 10/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
E - MACHINE ADJUSTMENTS
ËË
ËË
Ë
ÊÊ
ÊÊ
Ê
1.5 mm
ÌÌ
ÌÌ
Ì
ÎÎ
ÎÎ
Î
ÍÍ
ÍÍ
Í
1
2
7. CLUTCH
Clutch pressure is set up by the manufacturer. Under normal circumstances, it is not necessary to adjust it.
The correct torque is 0,42 Nm.
Hold the nut Ê and tighten the adjusting screw Ë with a torque wrench. Adjust the torque so that is even on
both sides of the clutch.
NOTE: If you do not have a torque wrench available, set ends of both screws so that screw-threads overlap
nuts edges of 1,5 mm.
CAUTION: If the torque is too small, fabric will not be fed in correctly.
If the torque is too big, it can damage some parts (gearwheels).
8. STITCH DENSITY
Adjust position of the feeding rod Ì in the density lever
groove Í in order to achieve right stitch density.
Increasing stitch density 1:
a) Loosen the hexagonal screw Î and move the rod
Ì from the bedplate. That will increase the stitch
density.
b) Tighten the hexagonal screw Î.
Maximal stitch density is 14 stitches per 10 mm.
Reducing stitch density 2:
a) Loosen the hexagonal screw Î and move the rod
Ì towards the bedplate. That will reduce the stitch
density.
b) Tighten the hexagonal screw Î.
Minimal stitch density is 3 stitches per 10 mm.