Service manual
Table Of Contents
- MODEL S 4000 CAED Omron
- WARRANTY
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE ASSEMBLY
- C-PROPER APLICATION
- D-MACHINE CONTROLS
- E-MACHINE ADJUSTMENTS
- G-PNEUMATIC DIAGRAM
- F-MACHINE MAINTENANCE
- 1.MACHINE HOME POSITION
- 2.ADJUSTMENT OF THE SHIFTER
- 3.PRINCIPLES FOR MACHINE ADJUSTMENT
- 4.NEEDLE BAR
- 5.BITE
- 6.FEEDING
- 7.CLUTCH
- 8.STITCH DENSITY
- 9.LOOPERS ADJUSTMENT
- 10.HOME POSITION OF THE CLAMP PLATE
- 11.CLAMP PLATE ADJUSTMENT
- 12.TRIMMING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF THE CLAMP PLATE CHANGE-OVER
- 14.ADJUSTMENT OF MACHINE HEAD CLAMPING FOOT
- 15.THREAD DRAW OFF
- 16.THREAD TENSION
- 17.THREAD TRIMMING
- 18.CUTS-OFF BLOW OFF
- 19.THREAD BLOW OFF (SPECIAL ACCESSORY)
- 20.ADJUSTMENT OF STOP SENSOR POSITION
- 21.REPLACEMENT OF THE BELT
- 22.PROTECTION DURING VOLTAGE FLUCTUATION (SPECIAL ACCESSORY)
- 23.OPTICAL SENSOR-ADJUSTMENT
- H-ELECTRICAL DIAGRAM
- TROBLESHOOTING-TABLE OF CONTENTS
S-4000 CAED Omron
1-23
Revised 10/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
D - MACHINE CONTROL
7. PARAMETER CHECKLIST
PARAMETER RANGE SETTING
MAX SPEED
1000-3800 rpm
3500
SLOW STITCH
0-3
0
SLOW SPEED
500-1000 rpm
1000
NDL UP POS
0-600 imp
320
KNIFE DELAY
60-150 ms
120
KNIFE TIME
30-200 ms
100
TRIM DELAY
0-200 ms
150
TRIM TIME
30-60 ms
50
CLAMP DELAY
0-100 ms
50
CYCLE DLY
500-2500 ms
500
CYCLING
yes/no
No
PEDAL
1 step / 2 steps
2 steps
DOUBLE SEW
1, 2 =1 or 2, 3 = 2
1
MATER. BLOW
10-1000 ms
40
DIRECTION
0-10 stitches
0
OPTICAL SENS
yes/no
yes
THREAD BLOW
10-1000 ms
30
SHIFT TIME
300-900 ms
400