Service manual

S-4000 CAED Omron
1-20
Revised 10/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE CONTROLS
5. TESTS
WARNING! TESTS CAN BE CARRIED OUT BY QUALIFIED SERVICE ENGINEERS ONLY!
CAUTION! BEFORE STARTING THE TESTS REMOVE CUTTING KNIFE AND NEEDLE.
With the main screen on the display, press
. appears on the display. In order to
enter TEST menu, press .
Intput tests
Off
Low air pres
appears on the display. You can browse through the
menu down by pressing the button or up pressing the button
F
2
.
INPUT (TESTS)
1.
Intput tests
Off
Low air press
- this appears on the display in case the air
pressure is lower than 0,5 MPa. This parameter checks the switch BQ2.
2.
Home sensor
Voltage Rly
Off
Off
- The end position sensor. Activate the sensor with a metal item.
Home sensor
Volt ag e Rly
On
O ff
appears on the display.
This parameter checks the switch BQ1.
3. - This only input signify if the voltage relay is installed on the machine. If
the power voltage drops below 185V,
Home sensor
Voltage Rly
O ff
On
appears
on the display. This parameter checks the relay VC 1 min.
4. - Once the foot pedal is pressed into the first position,
Pedal 1 step
Pedal 2 step
Off
On
appears on the display.
This parameter checks the switch SB4.
5.
Pedal 1 step
Pedal 2 step
Off
O ff
- After pressing the foot pedal into the second position,
Pedal 1 step
Pedal 2 step
On
O ff
appears on the display.
This parameter checks the switch SB5.
Display
Direction
(0-10 stitches)
0
- Setting up number of stitches sewn over
the edge of fabric / workpiece.
Press F3 to Rst
Counter: 4538
- Counter of total number of cycles
Return onto the main screen
Display
Display