Service manual

S-4000 CAED Omron
1-18
Revised 10/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE CONTROLS
Display Press Display Press
1.
- maximal speed. Range 1000-3800 spm.
2.
Slow stitch
(0-3)
0
- selecting the number of stitches in slow start. Range 0-3.
3.
Slow speed
(500-1000 rpm)
1000
- setting the slow start speed at the beginning of the sewing cycle. Range
500-1000 rpm.
4.
Ndl up pos
(0-600)
320
- correction of the needle bar upper position. Range 0 - 600 imp.
5.
Knife delay
(60-135 ms)
120
- setting the knife/draw-off delay. It is possible to set it in range 60-135
ms.
6.
Knife time
(30-200 ms)
100
- setting the timing of the knife/draw-off activation. It is possible to set it
in range 30-200 ms.
7.
Trim delay
(145-200 ms)
150
- setting the trim delay. It is possible to set it in range 145 - 200 ms.
8.
Trim time
(30-60 ms)
50
- setting the timing of trim activation. It is possible to set in range 30 - 60
ms.
9.
Clamp Delay
(0-100 ms)
50
- setting the clamp opening delay at the end of cycle.
It is possible to set in range 0-100 ms.
Display
Example: To change the sewing speed from 2000 to 3450
(3x)
(4x)
(5x)
á á
á
á
á
á
á
á
á
á
á
á