Service manual
Table Of Contents
- MODEL S 4000 CAED Omron
- WARRANTY
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE ASSEMBLY
- C-PROPER APLICATION
- D-MACHINE CONTROLS
- E-MACHINE ADJUSTMENTS
- G-PNEUMATIC DIAGRAM
- F-MACHINE MAINTENANCE
- 1.MACHINE HOME POSITION
- 2.ADJUSTMENT OF THE SHIFTER
- 3.PRINCIPLES FOR MACHINE ADJUSTMENT
- 4.NEEDLE BAR
- 5.BITE
- 6.FEEDING
- 7.CLUTCH
- 8.STITCH DENSITY
- 9.LOOPERS ADJUSTMENT
- 10.HOME POSITION OF THE CLAMP PLATE
- 11.CLAMP PLATE ADJUSTMENT
- 12.TRIMMING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF THE CLAMP PLATE CHANGE-OVER
- 14.ADJUSTMENT OF MACHINE HEAD CLAMPING FOOT
- 15.THREAD DRAW OFF
- 16.THREAD TENSION
- 17.THREAD TRIMMING
- 18.CUTS-OFF BLOW OFF
- 19.THREAD BLOW OFF (SPECIAL ACCESSORY)
- 20.ADJUSTMENT OF STOP SENSOR POSITION
- 21.REPLACEMENT OF THE BELT
- 22.PROTECTION DURING VOLTAGE FLUCTUATION (SPECIAL ACCESSORY)
- 23.OPTICAL SENSOR-ADJUSTMENT
- H-ELECTRICAL DIAGRAM
- TROBLESHOOTING-TABLE OF CONTENTS
S-4000 CAED Omron
1-17
Revised 10/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
4. THE PROGRAMMING MENU
Main screen
Ready
1239
- press á appears on the
display. To enter the programming menu, press
á appears on the
display. The first line of the display indicates the parameter, which is set, and the second line indicates the
range of setting. To scroll the lines down press key, to scroll the lines up, press key. To change
the value of any parameter, press key. Press key to set the first digit. Press key. The
second digit starts flashing on the display. To set the value, press key. Press key. The third digit
starts flashing on the display. Repeat this setting until all digits of the parameter are set. To confirm the set
value of a parameter, press key.
D - MACHINE CONTROLS
3. CONTROL PANEL INFORMATION (MAIN SCREEN)
ATTENTION! When doing any kind of adjustment, keep your hands off the needle area. The basic machine
design is equipped with a pedal control; therefore never place your foot onto the foot pedal.
Error messages on the display are mentioned in Troubleshooting section.
Daily cycle counter
Ready
1239
Display messages: ❍ Ready index on
❍ Emerg. Stop
❍ Service mode
❍ Wait please
❍ Ready F1
Service F6
❍ Motor not ready
❍ Low voltage
❍ Low air pressure
Standard messages:
Error messages: