Service manual

S-4000 CAED Omron
1-15
Revised 10/2009
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
D - MACHINE CONTROLS
1. PROGRESS OF SEWING
1. Bring the machine to the home position according to the section C1.
2. Be certain that the machine is threaded correctly according to the section C3 and insert the work
under the clamp feet.
3. When the foot pedal ➌ is pressed to the first position, the work is clamped by the clamp feet.
(Releasing the foot pedal will rise the clamp feet).
Note: It is possible to set in the program the machine start on first pedal position.
4. When the foot pedal is pressed to its second position, the sewing is started. After finishing the sewing
and trimming the thread, the machine returns to the home position and the clamp feet rise.
5. When the clamp feet are up, it is possible to move the sewn work for next sewing.
6. Machine can be stopped in any place of the cycle by pressing the Emergency Stop button ➍ which is
placed on the machine head. After releasing the Emergency Stop button, pressing the button
and pressing the foot pedal, the machine finishes the sewing.
7. If the foot pedal ➌ is pressed before finishing the sewing, the clamp feet will not rise and the
machine will sew four cycles instead of two - this is possible to set in program.
8. When the work is done, switch the machine off by the ➎ button.
➌
➎
➍