Service manual
Table Of Contents
- MODEL S 4000 CAED Omron
- WARRANTY
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE ASSEMBLY
- C-PROPER APLICATION
- D-MACHINE CONTROLS
- E-MACHINE ADJUSTMENTS
- G-PNEUMATIC DIAGRAM
- F-MACHINE MAINTENANCE
- 1.MACHINE HOME POSITION
- 2.ADJUSTMENT OF THE SHIFTER
- 3.PRINCIPLES FOR MACHINE ADJUSTMENT
- 4.NEEDLE BAR
- 5.BITE
- 6.FEEDING
- 7.CLUTCH
- 8.STITCH DENSITY
- 9.LOOPERS ADJUSTMENT
- 10.HOME POSITION OF THE CLAMP PLATE
- 11.CLAMP PLATE ADJUSTMENT
- 12.TRIMMING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF THE CLAMP PLATE CHANGE-OVER
- 14.ADJUSTMENT OF MACHINE HEAD CLAMPING FOOT
- 15.THREAD DRAW OFF
- 16.THREAD TENSION
- 17.THREAD TRIMMING
- 18.CUTS-OFF BLOW OFF
- 19.THREAD BLOW OFF (SPECIAL ACCESSORY)
- 20.ADJUSTMENT OF STOP SENSOR POSITION
- 21.REPLACEMENT OF THE BELT
- 22.PROTECTION DURING VOLTAGE FLUCTUATION (SPECIAL ACCESSORY)
- 23.OPTICAL SENSOR-ADJUSTMENT
- H-ELECTRICAL DIAGRAM
- TROBLESHOOTING-TABLE OF CONTENTS
S-4000 CAED Omron
1-13
Revised 10/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
C - PROPER APPLICATION
2. NEEDLE INSTALLATION
WARNING! Before doing this adjustment, switch the machine off and let the remaining compressed air from
the machine out.
For thin fabrics the machine uses needles order number 02.0750.2.109 (750 SC 70/10— Groz-Beckert) as
standard and for thicker fabrice needles order number 02.0750.2.110 (750SC 90/14— Groz-Beckert) – see
accessories. I tis possible to use needles order number 02.0750.2.100 (750 SC 80/12 - Groz-Beckert) for
thin fabrice – these needles are not in a standard accessory kit.
1. Using the screwdriver push the latch ➊ and open the needle bar cover ➋.
Note: The accessories contain the lever ➎ (part number 22.0213.0.000) and screw (part number
08.6000.4.005) with washer (08.6850.4.000) ➏, which is possible to fit to the latch. It allows
opening of the cover without using the tool.
2. Loosen the screw ➌ and remove the needle.
3. Insert the new needle so that the long thread
groove ➍ is in the rear and the spot for the
clamping screw ➌ is in line. Do not install a
bent or broken needle. Roll the needle on a flat
surface to check for straightness.
4. Tighten the screw ➌ well.
ÊÊ
Ê
Ê
Ê
ËË
ËË
Ë
➎
➏
Ê
Ê
ÊÊ
Ê