Service manual
Table Of Contents
- MODEL S 4000 CAED Omron
- WARRANTY
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE ASSEMBLY
- C-PROPER APLICATION
- D-MACHINE CONTROLS
- E-MACHINE ADJUSTMENTS
- G-PNEUMATIC DIAGRAM
- F-MACHINE MAINTENANCE
- 1.MACHINE HOME POSITION
- 2.ADJUSTMENT OF THE SHIFTER
- 3.PRINCIPLES FOR MACHINE ADJUSTMENT
- 4.NEEDLE BAR
- 5.BITE
- 6.FEEDING
- 7.CLUTCH
- 8.STITCH DENSITY
- 9.LOOPERS ADJUSTMENT
- 10.HOME POSITION OF THE CLAMP PLATE
- 11.CLAMP PLATE ADJUSTMENT
- 12.TRIMMING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF THE CLAMP PLATE CHANGE-OVER
- 14.ADJUSTMENT OF MACHINE HEAD CLAMPING FOOT
- 15.THREAD DRAW OFF
- 16.THREAD TENSION
- 17.THREAD TRIMMING
- 18.CUTS-OFF BLOW OFF
- 19.THREAD BLOW OFF (SPECIAL ACCESSORY)
- 20.ADJUSTMENT OF STOP SENSOR POSITION
- 21.REPLACEMENT OF THE BELT
- 22.PROTECTION DURING VOLTAGE FLUCTUATION (SPECIAL ACCESSORY)
- 23.OPTICAL SENSOR-ADJUSTMENT
- H-ELECTRICAL DIAGRAM
- TROBLESHOOTING-TABLE OF CONTENTS
S-4000 CAED Omron
1-7
Revised 10/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
A - INTRODUCTION
Connector Ø 8 Ê
- order it if the connecting tube has the inner diameter 8 mm.
The connector Ø 10 is supplied with the machine.
- part number is 12.0008.3.607
Reduction Ë
- place an order in case you use connections with inch threads
(order number 12.0008.3.081)
Hand valve Ì
- to dissipate any air from the machine, order it (air circuit is bled). It is necessary to order the
connectors (see below) to the hand valve for connection to the air tubes.
- part number 12.0008.3.463
Connectors
➍ 12.0008.3.464 Ø 8 for connection to the tube with inner Ø 8 mm
➎ 12.0008.3.466 Ø 10 for connection to the tube with inner Ø 10 mm
Ï 12.0008.3.467 Ø 12 for connection to the tube with inner Ø 12 mm*
Ð 12.0008.3.465 Ø 16 for connection to the tube with inner Ø 16 mm*
* To connect the tube with inner Ø 12 and Ø 16, it is also necessary to order Ø 10.
Thread Draw - Off Kit 03.5524.0.004
- order this device if
you would like to use
the machine for both,
sewing and trimming.
without
trimming
with trimming
Thread Blow - Off Kit 03.5524.0.023
- the device enables thread tail at
the needle to be caught above the clamping
feet