Service manual

S-4000 BH Omron
1-22
Released 05/2010
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
4. THE PROGRAMMING MENU
Main screen - press , appears on the
display. To enter the programming menu, press ke
y.
appears on the
display. The first line of the display indicates the parameter, which is possible to set, and the second line
indicates the range of setting. To scroll the lines down press ke
y, to scroll the lines up, press
ke
y. To change the value of any parameter, press
key. Press key to set the first digit.
Press k
ey. The second digit starts flashing on the display. To set the value, press
ke
y. Press
key again. The third digit starts flashing on the display. Repeat this setting until all digits of a
parameter are set. to confirm the set value of a parameter, press ke
y.
D - MACHINE CONTROLS
3. CONTROL PANEL INFORMATION
Display message: ❍ Ready
❍ Emerg. Stop
❍ Serv
ice mode
❍ Wait please
❍ Ready F1
Service F6
❍ Motor not ready
❍ Low voltage
❍ Low air pressure
Standard messages:
Error messages:
WARNING! Keep your hands aw
ay from the needle area during any adjustment. Machine start is controlled
by the foot pedal. Keep your foot off of the foot pedal.
Error messages on the display are mentioned in Troubleshooting section.
Daily cycle counter