Specifications

Revised 04/2007
e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service), [phone] (Spare Parts); Fax: [phone]
2-6
S-311
TROUBLESHOOTING
3. THE ELECTRONIC SYSTEM ERROR MESSAGES
If an error message appears on the display (see picture Ê), press it. The screen with a description and
a correction of an error message appears on the display (see picture Ë).
SYMPTOM
POSSIBLE CAUSE
PROBABLE SOLUTION
Ê
Ë
E-01
Machine is not in home position.
Press button to bring the
machine to the home position.
Cutting lever error.
Cutting lever error during cutting
Low air pressure. Air pressure
is below 3,5 bar.
Needle is not in the upper position
and the marks on the handwheel
and the cover are not aligned.
Check BQ7 sensor and the air
supply. Press and release
Emergency stop button to reset this
error message.
Check BQ7 sensor and air supply.
Check the air supply.
Turn the handwheel to align marks.
E-01
E-02
E-04
E-05
X axis positioning error.
Low voltage.
Cutting lever is not home.
Check X axis home sensor BQ2
and stepper motor.
Check power supply & voltage.
Check BQ7 sensor and air supply.
E-06
E-07
E-10
Y axis error.
X axis error.
R axis error.
Press buton.
Press buton.
Press buton.
Y axis positioning error.
Check Y axis home sensor BQ3
and stepper motor.