Service manual

e-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phones: [phone] (Service); [phone] (Spare Parts); Fax: [phone]
Revised 03/2006
S-311
1-55
E - STANDARD MACHINE ADJUSTMENT
19. ADJUSTMENT OF THE ADJUSTABLE CUTTING STEEL HOLDER
To adjust the adjustable cutting steel holder, follow the below mentioned steps:
19.1. The distance between the sensor plate and the rear edge of the adjustable cutting steel holder
is 14 mm.
19.2. The distance between the sensor plate and the sensor must be 0.3 mm.
19.3. Adjust the clearance 3.5 mm between the adjustable cutting steel holder and the timing belt pulley.
19.4. Adjust the distance 68 mm between the stop of the cutting lever and the point of the needle.
19.5. Loose the clamp screw Ê to adjust the correct cutting length by moving the cutting steel.
Ê