Service manual

Revised 11/2010
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
S-105
1-44
E - MAINTENANCE
3. MACHINE LUBRICATION
Before the machine is switched on for the first time, all preservative oils must be removed. It is also
necessar
y to lubricate all areas shown below. This must be done when the machine is not used for
some time too.
3.1 The machine is equipped with group lubrication system, which lowers demands for maintenance. There are
red spots indicating areas that need to be lubricated. Those areas must be lubricated at least 1-2 times per
week. The manufacturer recommends using lubrication oil ESSO TERESSO 32 or other oil of similar
characteristic.
3.2 The quantity of oil in the oil tank
with an oil gauge
is shown by a red mark. Too much oil can leak out.
Fill the empty oil tank with approximately 10 cm
3
of oil through the filling hole
Ê
Ê
ÊÊ
Ê.
3.3 Needle bar lubrication is done after loosing the
screw
ÌÌ
ÌÌ
Ì and after removal of the cover
ËË
ËË
Ë. Pour
a few drops of oil onto the needle bar
ÎÎ
ÎÎ
Î above
the bearing
ÍÍ
ÍÍ
Í, into the centre of the needle bar
ÎÎ
ÎÎ
Î where the spiral lubrication groove is, into
the gap between washers Ï and onto the flat
bite body
. Fitt the cover
Ë
Ë
Ë Ë
Ë again.
ÏÏ
Ï
Ï
Ï
ËË
Ë
Ë
Ë
ÌÌ
ÌÌ
Ì
ÍÍ
ÍÍ
Í
ÎÎ
ÎÎ
Î
ÊÊ
Ê
Ê
Ê