Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Revised 11/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
S-105
1-43
E - MAINTENANCE
2. SUMMARY OF MAINTENANCE
Once a day (10 hours) - visual inspection
- cleaning sewing mechanism area and inside the machine frame
WARNING: If the waste hole in the knife or
cutting block
Ê Ê
Ê Ê
Ê block, the knife breaks.
Once a week (80 hours) - visual inspection of outside and inside mechanisms
- lubrication of needle bar and sewing mechanism
- filling up oil into the oil tank with an oil gauge
- checking belt tension
- checking cutting knife and cutting steels, change parts if damaged
- checking operation of stop mechanism, especially brakes
- checking stitch plate wear out, exchange if necessary
Once a month (300 hours) - checking clearances in the sewing mechanism drive
- checking screw joinings (keep the values stated below)
Ê
Recomended values of screw tightening (Nm)
M3
M4
M5
M6
M8
M10
0,5
1,2
2,5
4,0
0,6
1,5
3,0
5,0
8,0
10,0
0,8
2,0
4,0
7,0
16,0
30,0