Service manual

Revised 11/2010
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
S-105
1-42
WARNING: - Do not miss out regular maintenance work.
- If electricity supply is cut off
, turn the main switch off.
- Do not damage, modify or remove the safety labels.
- Do not work on the machine intoxicated or impaired.
CAUTION: - Check electricity cables that they are not damaged.
- Check that all safety covers are in good condition. Replace damaged covers or order new ones!
- Never put your fingers into the sewing mechanism and needle area.
- Never modify the machine in a way that may endanger its safety.
1. MACHINE CLEANING AND MAINTENANCE
1.1 Switch the power supply off.
1.2 To clean and lubricate mechanisms, we need
to remove the clamp plates to get access to
the sewing mechanism. Turn the security
latches
Ê
Ê
ÊÊ
Ê. Lift up the feet and move them
onto you. Then tilt the back cover
ÍÍ
ÍÍ
Í.
1.3 Clean the sewing mechanism, guides and
thread tensors from thread and fabric remains.
It is possible to turn the sewing mechanism
by the hand wheel on the right side of the
machine. The machine head can be lifted and
secure with the support controlled by this
button
ÎÎ
ÎÎ
Î. Pressing the button
ÎÎ
ÎÎ
Î will let the
head be lowered down into the operation
position.
CAUTION! When lowering the machine head,
lift up the machine a little bit by resting your hand
on the front cover Ð. Watch your fingers! Injury
hazard!
1.4 Lubricate the machine as in Section E3
1.5 Once the inspection and service is finished,
close the cover
ÍÍ
ÍÍ
Í, while the head is tilted
into operational position, insert and secure the
clamp plates with latches
ÊÊ
ÊÊ
Ê. Now you can
continue working.
E - MAINTENANCE
ÎÎ
ÎÎ
Î
ÊÊ
Ê
Ê
Ê
ÍÍ
ÍÍ
Í
Ð