Service manual

Revised 11/2010
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
S-105
1-41
D - MACHINE ADJUSTMENT
13.5. Adjustment of safety latch – turn the left wheel. Once the machine is in the home position and feet levers
release, the safety latch should be above the groove placed on the tip of the square . To make adjustment,
loosen scr
ews
and move the support upwards or downwards as necessar
y so that the latch
drops
into the gr
oove. Once the adjustment is done, tighten the screws
. The minimal play required betw
een
the lever and the tip of the clamping arm is 0,8 mm. To adjust it, loosen the screw
and turn the eccentric
n
ut as needed
. Tighten the scr
ews after the adjustment.
13.6. Selection of cut before (CB) or cut after (CA)
Changing CB for CA
1. Change the machine over fr
om the home position (half of the sewing cycle).
2. Move the lever
that is placed on the left side in the rear part of the machine head into the CA position.
3. Loosen the screw and move the guiding tra
vel
backwards, to the CA position. Once the guiding
tra
vel is moved backwards, tighten the screw
.
Changing CA for CB
1. Change the machine over fr
om the home position (half of the sewing cycle).
2. Move the lever
that is placed on the left side in the rear part of the machine head into the CB position.
3. Loosen the screw and move the guiding tra
vel
forward
, to the CB position. Once the guiding travel
is moved forward, tighten the screw
.
0
,
8
m
m