Service manual

ManualsBrandsAMF ManualsBusiness equipmentS-105

Table Of Contents

MODEL S 105

Revised 11/2010

E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phone: +420 582 309 286; Fax: +420 582 360 606

S-105

1-40

D - MACHINE ADJUSTMENT

13.1. The basic position of the clamp plates with clamp feet can be adjusted by turning the left hand wheel.

The rolls

Ê Ê

Ê on the knife holder wedge spreader and the clamp plates are spread. Loosing the screws

Ë Ë

Ë make sit possible to adjust the stoppers

ÌÌ

Ì. The gap X should be same on both plates (asi 0,8 mm).

Alignment of plates is adjusted by the stud

ÍÍ

Í. Once it is loosen, check that the distance V is the same

for both clamp plates from the knife cut.

13. ADJUSTMENT OF CLAMPING MECHANISM

13.2. In order to prevent the needle hitting the clamp foot, it is possible to adjust the position of the foot by

loosing the screws

Î Î

Î vertically onto the sewn buttonhole (the recommended gap between the foot

and a row of stitches is 0,8 mm) and in longitudinal axis once you loose the screws

ÏÏ

Ï.

13.3. With its design, the clamping mechanism enables clamping material of different thickness. Clamp a

piece of material manually with a lever

ÐÐ

Ð to adjust the pressure. Use the hand wheel on the left side

and turn the main cam so that the ramp

Ñ Ñ

Ñ lowers down the whole operating mechanism as much as

possible. Loosen the stud nut

Ó Ó

Ó to adjust its position with the screw

, once you loosen the nut so

that the lever leans against the bottom square surface . Test the function.

.4. Loosen the nut and adjust the height of the feet

above the plates

Ò Ò

Ò 10 mm can be adjusted with a

screw

NOTE:

It is suitable to check the function of the mechanism to adjust levers for both, cut after (CA) and cut

before (CB) seaming.

0,8 mm

1,5 - 2,0 mm

ÎÎ

ÒÒ

ÊÊ

ÑÑ

ÐÐ

ÓÓ

2 mm

4 mm

ÍÍ

ÏÏ

ÌÌ

ËË