Service manual

ManualsBrandsAMF ManualsBusiness equipmentS-105

Table Of Contents

MODEL S 105

Revised 11/2010

E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phone: +420 582 309 286; Fax: +420 582 360 606

S-105

1-35

D - MACHINE ADJUSTMENT

9.1. Once the holder with the trimming knife

Ê Ê

Ê is

fitted in again, adjust the height of the knife to

reach the play of 0,1-0,15 mm above the right

spreader

ÍÍ

Í and tighten the screw

ÌÌ

Ì. Once the

stitching plate is fitted in, there must be some

distance between the plate and the adjusted knife.

9.2. The basic angle adjustment of the trimming knife

Ê Ê

Ê is done by the screw

Ë Ë

Ë so that the left side

of the knife leaves the groove in the stitching

plate

ÑÑ

Ñ. Adjsut the knife so that the knife edge

overlaps the edge of the stitching plate of 2mm.

9.3. The position of the knife

Ê Ê

Ê to catch the upper

thread loop can be changed by loosing the screw

ÎÎ

Î so that the knife edge is 0,9 mm from the

needle

ÏÏ

Ï. If the position of the knife changes,

it is necessary to check the height – to keep the

play as in part 9.1.

9.4. Adjsut the basic position of the actuator

ÒÒ

Ò with the screw after loosing the nut

, so that

the distance from the arm

Ó Ó

Ó is 0,5 mm.

9.5. The trimming is adjusted by tilting the lever

Loosen the screw . Tilting the lever further

into the direction of the roll travel will make

the trimming mechanism action longer. If the

lever tilting into the direction of the roll travel

is smaller, the tr

immenig mechanism action

will be shorter.

WARNING: Maximal knife tilt Ê, is adjusted at the

manufacturer. The trimming knife Ê must not catch

with its tip the bottom thread Ð.

9. UPPER THREAD TRIMMING

ÍÍ

ËË

Position of looper during trimming

(sewing mechanism closed)

ÍÍ