Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Revised 11/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
S-105
1-30
D - MACHINE ADJUSTMENT
5. BUTTONHOLE SHAPE ADJUSTMENT
To adjust the buttonhole shape,
it is necessary to create a new stitching pattern.
5.1. Check the new stitching pattern and determine where to adjust the nut
ÊÊ
ÊÊ
Ê to obtain the right eye shape. Use
the examples below as guidance.
5.2. Once you loosen the nut
ÊÊ
ÊÊ
Ê placed on the lever
ËË
ËË
Ë move this nut upwards or downwards as needed. If the
eye shape corresponds with the picture in the example A, move the nut
ÊÊ
ÊÊ
Ê downwards. If the eye shape
corresponds with picture in B, move the nut
Ê Ê
Ê Ê
Ê upwards.
5.3. Tighten the nut
ÊÊ
ÊÊ
Ê after the adjustment. Start the machine and make another stitch pattern. If we did not obtain
the required eye shape on the sample, repeat the above mentioned steps.
NOTE: It is a standard procedure to repeat the process several times.
Buttonhole
shape:
Example A
Example B
Ê
Ë