Service manual

Revised 11/2010
E-mail: [e-mail]; [e-mail]; website: www.amfreece.com
Phone: [phone]; Fax: [phone]
S-105
1-29
When the machine does not move, turning segments
Ê
Ê
ÊÊ
Ê,
Ì Ì
Ì Ì
Ì are adjusted on the right in the machine axis onto
the second segment gear. Supporting area of the looper holder
Ñ Ñ
Ñ Ñ
Ñ is in vertical position on the table axis
ÒÒ
ÒÒ
Ò. The
looper mechanism is adjusted after loosing the screw
ËË
ËË
Ë needle bar mechanism after loosing the screw
ÍÍ
ÍÍ
Í. Tension
disks
ÐÐ
ÐÐ
Ð are forward-facing. Adjust the symmetric turning with the stud
Î Î
Î Î
Î , and turning sewing mechanism
onto 180
o
± 2
o
with the stud
ÏÏ
ÏÏ
Ï
D - MACHINE ADJUSTMENT
4. NEEDLE BAR AND RACE ALIGNMENT
WARNING: It is very important to move the looper
mechanism of 180
o
only. The turning must be vertical
and onto horizontal table axis
Ò
Ò
Ò Ò
Ò the correct bite of the
needle bar must be in the same distance from the looper
mechanism (the needle cannot move further or closer to
the edge of the throat plate).
ÐÐ
Ð
Ð
Ð
ÌÌ
ÌÌ
Ì
ÍÍ
ÍÍ
Í
ÎÎ
Î
Î
Î
ÏÏ
ÏÏ
Ï
ÊÊ
ÊÊ
Ê
ËË
ËË
Ë
ÑÑ
Ñ
Ñ
Ñ
ÒÒ
ÒÒ
Ò