Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Revised 11/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
S-105
1-27
D - MACHINE ADJUSTMENT
0
,
1
-
0
,
2
m
m
Ì
Ë
0,1-0,2 mm
ÒÒ
ÒÒ
Ò
Ó
Ó
ÓÓ
Ó
OBR. II
5 mm
ÊÊ
Ê
Ê
Ê
2.6. Adjustment of the clearance 5 mm between the stopping
wheel and lever . Dissamble the hand wheel
ÊÊ
Ê
Ê
Ê and then
the stopping mechanism. Pull out the stopping screw
from
the stopping mechanism and disasemble the safety ring
ÒÒ
Ò
Ò
Ò.
release the screw
ÓÓ
ÓÓ
Ó on the clutch, so the lever
can be
moved and turned. Put the clutch mechanism to the shaft and
adjust the way that by the clutch stroke (anticlockwise) and
after putting the hand wheel, the clearance will be 5 mm be-
tween the edges of the stopping w
heel and lever
. Tighten
the screw
ÓÓ
Ó
Ó
Ó. remove the stopping wheel and the clutch
mechanism from the shaft. Put on the clutchmechanism into
the stopping wheel and the safety ring and secure with the
screw
. Adjust the stopping mechanism on the shaft, put on
the hand wheel and secure with the nut.