Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Released 01/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-25
Lift up the machine head into vertical position over the cam case, turn the left hand wheel and check that
the pistons go into the guiding travel
Î
Î
Î Î
Î freely. If not, loosen the screw
ÐÐ
ÐÐ
Ð of the lever
ÑÑ
ÑÑ
Ñ and adjust the
table position with the cam
ÏÏ
ÏÏ
Ï, tighten the screw
ÐÐ
ÐÐ
Ð again as needed.
D - MACHINE ADJUSTMENT
1. TABLE ADJUSTMENT
WARNING:
At the manufacturer, the stud holder
ÍÍ
ÍÍ
Í is fitted with small wedges and fixed with a pin. Do
not change the position of wedges. Switching over the stud can be adjusted after turning the cam into the
position when the roll
ËË
ËË
Ë is in the position
ÒÒ
ÒÒ
Ò of cam travel
ÌÌ
ÌÌ
Ì. The stud
ÍÍ
ÍÍ
Í should leave the groove
ÎÎ
ÎÎ
Î in
the cam at this point. If not, adjust the
Ó Ó
Ó Ó
Ó bracket as needed once you loosen the screw
.
Í
Ó
Ñ
Ê
Ð
Ë
Ì
Ò
Î Ï