Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Released 01/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-23
C - CORRECT USAGE
The change of the position of stitch rows is used especially when the thickness of the sewn material
changes or when the machine is adjusted from cut before to cut after and vise versa.
Loose the nut
Ê
Ê
ÊÊ
Ê turn the eccentric
ËË
ËË
Ë and use the screwdriver to change the setting as per the drawing.
Once the nut is set
ÊÊ
ÊÊ
Ê tighten it firmly.
9. CHANGING THE POSITION OF STITCH ROWS – GAPS FOR CUT
WARNING: When you change the gap between both rows of stitches, you may need to adjust the sewing
mechanism as well.
10. SETTING THE SPREAD OF THE CLAMP FEET
Different types of material require larger or smaller spread of the material between the clamp feet. In order
to change the spread, use the setting shown in the picture.
Loosen the screw
ÊÊ
ÊÊ
Ê at each side of the machine and move the setting stops
ËË
ËË
Ë inward →A, to make the
spread wider - and outward →B, to make the spread narrower.
NOTE: Make sure that the spread is equal on both sides.
Ë
Ë
ËË
Ë
ÊÊ
Ê
Ê
Ê
ÊÊ
ÊÊ
Ê
ËË
ËË
Ë