Service manual
Table Of Contents
- MODEL S 105
- LIMITED WARRANTY ON NEW AMF REECE EQUIPMENT
- WARRANTY REGISTRATION CARD
- TABLE OF CONTENTS
- A-INTRODUCTION
- B-MACHINE INSTALATION
- C-CORRECT USAGE
- 1.SEWING A BUTTONHOLE
- 2.NEEDLE EXCHANGE
- 3.THREADING THE MACHINE
- 4.PRINCIPLES OF SEWING
- 5.MACHINE DESCRIPTION AND ITS FUNCTIONS
- 6.CHANGING SEAMING WIDTH
- 7.STITCH DENSITY ADJUSTMENT
- 8.STITCHING LENGHT AND FLYBAR ADJUSTMENT
- 9.CHANGING THE POSITION IF STITCH ROWS-GAPS FOR CUT
- 10-SETTING THE SPREAD OF CLAMP FEET
- D-MACHINE ADJUSTMENT
- 1.TABLE ADJUSTMENT
- 2.STOPPING MECHANISM
- 3.BRAKE ADJUSTMENT
- 4.NEEDLE BAR AND RACE ALIGNMENT
- 5.BUTTONHOLE SHAPE ADJUSTMENT
- 6.NEEDLE BAR HEIGHT
- 7.LOOPERS ADJUSTMENT
- 8.SPREADERS ADJUSTMENT
- 9.UPPER THREAD TRIMMING
- 10.UPPER THREAD TENSION
- 11.SEWING SWITCH LEVER
- 12.CUTTING MECHANISM ADJUSTMENT
- 13.ADJUSTMENT OF CLAMPING MECHANISM
- E-MAINTENANCE
- TROUBLESHOOTING
Released 01/2010
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-13
6. ADJUSTMENT OF RIGHT DRIVE BELT
B - MACHINE INSTALLATION
10 N
25 mm
3
0
m
i
n
1
2
3
4
5
6
The drive belt
ÊÊ
Ê
Ê
Ê is placed under the right side cover
ËË
ËË
Ë. The cover can be pulled and removed by loosing
the adjusting screw
ÌÌ
ÌÌ
Ì placed in the upper part of the cover and by removing the side screw Í. Once the
cover is removed loose the pulley screw
ÎÎ
ÎÎ
Î and adjust the V-belt pulley
ÏÏ
ÏÏ
Ï so that the slack of the front
belt part is about 25 mm (1”) when pushing on it, as shown in the picture below. Tighten the screw of the
tension pulley
ÎÎ
ÎÎ
Î. In order to tilt the machine head easily, the pulley must be down with the tilt at least 30°
backwards. Place the removed cover back onto the machine
ËË
ËË
Ë.