Service manual

Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
E - STANDARD MACHINE
2. SUMMARY OF MAINTENANCE
Once a day (10 hours)
- visual inspection
- cleaning sewing mechanism area and inside the machine frame
- lubrication of rare shaft (see section 3.1)
WARNING! If the waste hole in the knife
2
or incudes
1
block, the knife breaks.
Once a week (80 hours)
- visual inspection of outside and inside mechanisms
- lubrication of needle bar and sewing mechanism
- lling up oil into the oil tank with an oil gauge
- checking belt tension
- checking cutting knife and cutting steels, change parts if damaged
- checking operation of stop mechanism, especially brakes
- checking stitch plate wear out, exchange if necessary
Once a month (300 hours)
- checking clearances in the sewing mechanism drive
- checking screw joinings (keep the values stated below)
Recomended values of screw tightening (Nm)
M3
M4
M5
M6
M8
M10
0,5
1,2
2,5
4,0
0,6
1,5
3,0
5,0
8,0
10,0
0,8
2,0
4,0
7,0
16,0
30,0
1-47
S-101.M