Service manual

CA CB
Released: 10/2013
E-mail: [e-mail]; webside: amfreece.com
Phone: [phone]; Fax: [phone]
D - MACHINE ADJUSTMENT
15. CUT BEFORE AND CUT AFTER ADJUSTMENT
The change between cut after/before is ensured by two functional components, change of the lever
1
position, up
left back and by shifting the control lever
2
down. After rearrangement it is necessary to twice mechanically test the
machine cycle (without sewing) - the rst cycle is usually incomplete. Make the adjustment in the home position:
15.1. Move the lever
1
into the selected position CA or CB (CA = cut after, CB = cut before).
15.2. Loosen the screw
3
and move the control lever in the A direction for cut after, in the B direction for cut before.
Tighten the screw
3
.
WARNING!
Stop screw
4
is adjusted from the manufacturer. Do not manipulate with this stop unles you have serious reason.
CAUTION!
Both components must be adjusted for the same sewing type - either CA or CB!
S-101.M
1-45